![]() ![]() I then asked a fellow forum member to do some tests and he found the slippage to be significant with dyneema to dyneema at relatively low loads. However this was not dyneema to dyneema contact dyneema is slippery stuff with relatively low coefficient of friction. As an experiment, I even flew some sleeved connections with larks head without any bury just a safety stopper knot and they stayed in place without slipping to the safety stopper knot. I assume you have no stitching, in which case I would not use them, without proof testing! I used to have the same philosophy as Ozbunny, and it is obvious that the larks head provides helpful friction. Then you can design whatever you're happy with. Make sure you understand what is happening with each element of the project. #Brummel splice 2 ends trialTake in all the tips and techniques then sit down and trial a bunch of options. You can't make them to a specific length (because the pass through and the bury all consume length) but you can make a consistent set of pigtails then use other parts of the bar and lines to do fined adjustment.ĭon't believe all the comments you get about knots and stuff. It's easier to make things to a specific length if you can slide the loop to suit.Īlternatively, consistenly mark up your Brummel pigtails and make them all the same. If you're going to sew you can get rid of the Brummel too. That eliminates the thin section in the middle. ![]() My preferred way of splicing pigtails is to use a longish bury at both ends and pull them all the way down so they pass each other (so you have a double thickness inside) then taper and pull back then sew. The lines attaching are hitched on so the bury never really gets much load on it, especially if you're doing a Brummel. Realistically, for pigtails you don't need much bury at either end. You could just as easily have a straight length of line with a knot in it. You're really only doing a bury for cosmetic reasons. ![]() You don't need much bury for the knot end. Do the tail through the line method for the knotted end and the loop through the line method for the loop end. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |